Air King VS80 Petunjuk Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Penyedot Debu Air King VS80. Air King VS80 2 halaman. Central vacuums
Juga untuk Air King VS80: Panduan Pemilik (12 halaman), Petunjuk Instalasi (2 halaman)
Halaman Cetak
Inverted bag systems contInued:
Your VS80 power unit is supplied with a 12" muffler ( Picture # 10 ) and a 45 degree spigot coupling that is to be connected in line to the air
discharge port at the top of your VS80 power unit. Push the 45 degree spigot coupling onto the exhaust port at the top of The VS80 ma-
chine. Important: Do not glue this coupling in place. ( Picture # 11-12 )
Connect the low
volt wire from your
piping system to the
two spade crimp
connectors on the
side of the machine.
(Picture # 15)
pIc. 15
Check each valve in the home to insure system activation through your hose and the system operates as intended.
pIc. 10
pIc. 13
Corporate Headquarters for United States division:
820 Lincoln Avenue
•
You can then connect the muffler directly to the spigot
end of the coupling or use a 90 degree sweep to direct
the exhaust and muffler up from the machine further
dampening noise. ( Picture # 13 ) ( Picture # 14 )
pIc. 14
Once your VS80 power unit is fully installed connect the
power to the machine. You can confirm the unit is powered
by the activation of the LED on the side of the machine. You
can confirm machine operation by using the on-off switch
located near the top of the power unit ( Picture # 16 ). Note:
The power switch on the side of the unit is wired for opera-
tion of the machine independent of the low volt wiring circuit
to permit machine operation should a fault occur in your low
volt wiring circuit or the related control board and you are
waiting for service.
16
West Chester, PA 19380
pIc. 11
Ph.
800.465.7300
Website:
www.airkinglimited.com
pIc. 12