Electrolux 400 LT Panduan Instalasi dan Pengoperasian - Halaman 29

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Kulkas Electrolux 400 LT. Electrolux 400 LT 32 halaman. Vertical refrigerators

Halaman Cetak

• remove the temporary support and turn the door 180℃;

• remove spiral bushing "F", move pin "L" from the slotted

hole on the left to that on the right. Fit spiral bushing "F" on it,

turned 180℃;

• remove upper bracket "G";

• refit the door on the lower left hinge;

• refit bracket "G" on the left side of the cabinet;

• adjust the door, ensuring perfect adherence of the magnetic

seal and refit the top cover

I I M M P P O O R R T T A A N N T T

Reversing the opening of glass doors is

possible only on single module positive

temperature versions.

J J . . 2 2 . . 3 3

R R e e v v e e r r s s i i n n g g o o p p e e n n i i n n g g f f o o r r h h i i g g h h f f e e e e t t m m o o d d e e l l s s

The cabinets are normally supplied with right hinging. To

reverse opening, proceed as follows:

Fully insulated door models

• turn off the main switch and disconnect the plug;

• remove the upper cover;

• arrange a support (not supplied) for placing at the bottom

part of the door;

• undo the screws "H", remove the foot and lower bracket "E";

• screw in the foot, remove the temporary support and turn

the door 180℃

• remove spiral bushing "F", move pin "L" from the slotted

hole on the left to that on the right. Fit spiral bushing "F" on it,

turned 180℃

• unscrew the left foot, position lower bracket "E" and screw

on the bracket and foot.

• remove upper bracket "G" and bushing "I";

• refit the door on the lower left hinge;

• refit bracket "G" on the left side of the cabinet and bushing

"I" on the left side of the door;

• adjust the door, ensuring perfect adherence of the magnetic

seal and refit the top cover.

"Wine-line" and glass door models

• turn off the main switch and disconnect the plug;

•

remove the upper cover;

• arrange a support (not supplied) for placing at the bottom

part of the door;

• undo the screws "H", remove the foot and lower bracket "E";

• screw in the foot, remove the temporary support and turn

the door 180°;

• remove spiral bushing "F", move pin "L" from the slotted

hole on the left to that on the right. Fit spiral bushing "F" on it,

turned 180°;

• unscrew the left foot, position lower bracket "E" and screw

on the bracket and foot.

• remove upper bracket "G";

• refit the door on the lower left hinge;

• refit bracket "G" on the left side of the cabinet;

• adjust the door, ensuring perfect adherence of the magnetic

seal and refit the top cover.

I I M M P P O O R R T T A A N N T T

Reversing the opening of glass doors is

possible only on single module positive

temperature versions.