Electrolux Clarus Vibe WH6-14LAG Panduan Instalasi - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Mesin cuci Electrolux Clarus Vibe WH6-14LAG. Electrolux Clarus Vibe WH6-14LAG 32 halaman. Washer extractor

Halaman Cetak

7.1 Jetsave and Dosave

7.1.1

Connection of the tube

The machine is prepared for connection to the dosing systems Jetsave and Dosave.

The connections are closed at delivery. Open any of the connections that shall be used by drilling a hole where the

tube shall be connected.

Note!

Make sure there is no burrs left after drilling. When removing burrs make sure burrs does not fall into the si-

phon breaker.

A = ⌀ 17 mm (used for dosing systems).

B = ⌀ 6 mm (used for dosing systems).

C = Only used for flush manifold. (Separate instructions enclosed when ordering).

Always connect hoses on connections (A) with a hose clamp.

For connections (B); if the hoses are made of a soft material such as silicone or similar, use a cable tie to fasten the

hose on the connection. If the hoses are made of a hard material, it is not recommended to make the connection

tighter by using a cable tie.

Note!

Equipment for external dosing must only be connected to work on pump pressure and not on network

pressure.

Installation manual