Alen BreatheSmart Panduan Pengguna - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembersih Udara Alen BreatheSmart. Alen BreatheSmart 11 halaman. Hepa air purifier
Juga untuk Alen BreatheSmart: Panduan Pengguna (7 halaman)
Halaman Cetak
- 1. Table of Contents
- 2. Air Purifier Safety
- 3. Operating Your Unit
- 4. Using Your Air Purifier
- 5. Identification of Parts
- 6. Turn Lights Off/On
- 7. Care & Maintenance
- 8. Replacing the Filter
- 9. Know Your Air Purifier
- 10. Why You Should Replace Your Filter
- 11. How to Replace the Filter
- 12. How to Clean the Smartsensor
- 13. Troubleshooting Tips
- 14. Lifetime Limited Warranty
uSing your Air Purifier
operating your unit:
1.
Plug your air purifier into a grounded outlet.
2.
Press
Power Button in the center to start the air purifier. When your unit is on, the
lights will light up. To turn off the lights on your unit, press the
off the air purifier, press the
3.
The Colored Light around the
by the particle sensor.
Color
Blue
Yellow
Red
4.
Press ION to activate the ozone safe ionizer. Activation of ION enhances your unit's ability
to remove airborne particles (similar to the way dust is attracted to a TV screen). Press
ION again to turn off.
5.
FILTER LIFE Indicator — The Filter Life indicator has 3 lights: Green, Yellow and Red.
The Green light will be illuminated for most of the life of the filter. The Yellow light will
come on shortly before your filter should be replaced. This is the ideal time to order a new
filter. The Red light will be illuminated when it is time to replace the filter.
6.
After changing the filter, hold the FILTER LIFE button down for 5 seconds. The Red light
will be reset to Green.
7.
Press TIMER to have the air purifier run for a set amount of hours (either 4, 8 or 12)
before turning off.
8.
Press SPEED and watch the indicator lights until desired fan speed is achieved. Most
users prefer to use the air purifier on speed 2 or 3 to balance cleaning speed and noise. If
you suspect the air is particularly dirty, you should set the speed to T (Turbo).
9.
Press AUTO to set the unit on Automatic Mode. Automatic Mode will use the SmartSen-
sor Technology to adjust the speed of the unit depending on the amount of particles
present in the air.
Power Button again after the lights have turned off.
Power Button indicates the air quality being measured
Meaning
Low quantity of airborne particles detected
Moderate quantity of airborne particles detected
Significant quantity of airborne particles detected
www.AlenCorp.com 1-800-630-2396
Power Button. To turn
5