Bosch 1617EVSPK Panduan Petunjuk Pengoperasian/Keselamatan - Halaman 17
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian/Keselamatan untuk Alat Listrik Bosch 1617EVSPK. Bosch 1617EVSPK 24 halaman. Router tools
Juga untuk Bosch 1617EVSPK: Panduan Pengguna (34 halaman)
Halaman Cetak
BM 2610018532 01-12:BM 2610018532 01-12.qxp 1/23/12 9:21 AM Page 17
ROUTER DUST COLLECTION
There are three optional dust extraction hood
accessories. Each dust extraction hood is
sized to accept 35mm vacuum hoses. Each
accessory pack includes the VAC002 adapter
that will connect the hood to 1-1/4" and 1-1/2"
vacuum hoses. An adapter to connect the
hood to 2-1/2" hoses is also available
separately.
ROUTER DUST COLLECTION FOR
PLUNGE BASE
This dust extraction hood is designed for use
the plunge base (RA1166) when routing is
done in the middle of the workpiece, such as
when creating slots or routing patterns for
inlays. If you have a shop vacuum system, you
can attach the dust extraction hood for
improved visibility, accuracy and utility,
particularly in freehand routing.
To attach, position as shown and secure
adapter to base with the thumbscrews
provided (Fig. 16).
DUST EXTRACTION HOOD FOR
BACKSIDE OF FIXED BASE
Read and understand these
WARNING
!
instructions
manual for use of these accessories.
Do not reach in area of the bit while the
router is ON or plugged in.
To avoid entangling hoses,
CAUTION
!
do not use this dust
extraction hood at the same time as any
other dust extraction hood.
This dust extraction hood is designed for use
with Bosch routers 1617, 1617EVS, 1618EVS
and their fixed bases when the routing is done
in the middle of the workpiece, such as when
creating slots or routing out patterns for inlays.
To attach the hood to the router base, slide
the hood into the backside of the router base
around the router's depth adjustment rod with
the hood's rounded corners facing up (Fig. 17
& 18). Securely tighten the two knurled
thumbscrews.
USING THE HOOD FOR BACKSIDE OF
FIXED BASE
For maximum dust collection effectiveness,
make sure the router's chip shield is in place.
FIG. 16
DUST EXTRACTION HOOD
(Optional Accessory)
The dust extraction hood can also be installed
with the hose outlet facing the front of the tool.
If the templet guide adapter is installed, it will
need to be reversed or removed to allow the
release lever to fit under the dust hood.
FIG. 17
and
tool
M5 SCREW
DUST
EXTRACTION
HOOD
FIG. 18
-17-
M4 THUMB
SCREWS
ROUTER
BASE