Bosch 2 Buku Petunjuk - Halaman 10

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Bosch 2. Bosch 2 42 halaman. Mini blender
Juga untuk Bosch 2: Panduan Instalasi Cepat (16 halaman), Panduan untuk Instalasi dan Penggunaan (18 halaman), Manual Petunjuk Asli (13 halaman), Manual Petunjuk Asli (22 halaman), Buku Petunjuk (32 halaman), Panduan Pengguna (28 halaman), Panduan Pengguna dan Petunjuk Instalasi (16 halaman), Buku Petunjuk (42 halaman), Panduan Petunjuk Pengoperasian (8 halaman), Buku Petunjuk (8 halaman), Buku Petunjuk (12 halaman), Panduan Memulai Cepat (2 halaman), Panduan Memulai Cepat (9 halaman), Buku Petunjuk dan Petunjuk Instalasi (36 halaman), Panduan Pengguna dan Petunjuk Instalasi (48 halaman), Panduan Petunjuk Pengoperasian (26 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna dan Petunjuk Instalasi (24 halaman), Informasi Untuk Penggunaan (28 halaman), Panduan Pengguna (40 halaman), Panduan Pengguna dan Petunjuk Instalasi (35 halaman), Panduan Pengguna (24 halaman)

Halaman Cetak
Bosch 2 Buku Petunjuk
en

Water softening system/Special salt

+
Water softening
system/Special salt
W a t e r s o f te n i n g s y s te m /S p e c i a l s a l t
To ensure good washing results,
the dishwasher requires soft water, i.e.
containing low amounts of lime,
otherwise white limescale will be
deposited on the utensils and inner
container.
Tap water above 1.2 mmol/l must be
softened. The water is softened with
special salt (regeneration
salt) in the water softening
system of the dishwasher.
The setting and therefore the required
amount of salt
depends on the degree of hardness of
your tap water (see table).

Setting

The amount of salt dispensed can be
set from :
to :
Salt is not required at the set
value :
.
1. Find out about the hardness value of
your tap water. Your water utility
company will help you with this.
2. Set value can be found in the water
hardness table.
3. Close the door.
4. Switch on ON/OFF switch (.
5. Press and hold down the START
button @.
6. Rotate programme selector 8
until : ... is indicated on the digital
display H.
7. Release button.
The factory set value :
the digital display H.
10
.
is lit on
To change the setting:
1. Rotate programme selector 8 until
the required value is indicated on the
digital display H.
2. Press START button @.
The set value is saved.

Water hardness table