Electrolux ZUCA1 Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin pencuci piring Electrolux ZUCA1. Electrolux ZUCA1 14 halaman.

Halaman Cetak

B INSTRUCTIONS FOR THE INSTALLER/MAINTENANCE PERSON

Install a disconnecting switch with a capacity at

least equal to that given in the technical data table,

a 30mA residual current circuit breaker and an

overcurrent device (magnetothermal cut-out with

manual reset or fuse) between the appliance and

the mains power outlet.

The chosen device must be lockable in the open

position in case of maintenance.

RATING PLATE

The rating plate contains identification and technical

data and is located on the right-hand side panel of the

appliance (Figure 5).

Figure 5

WATER CONNECTION

CAUTION

Watermark labelled machines must be installed in

accordance with AS/NZS 3500.1.

If the dishwasher is installed under a worktop, make

sure the dimensions of the space in which it is placed

match those given in Figure 6.

Figure 6

Position the dishwasher and level the appliance by

turning the relative height-adjustable feet (Figure 5).

If the dishwasher is installed on a suitable support (e.g.

worktop); proceed as follows:

Access the bottom of the machine and unscrew the

4 feet.

Model LS5

PNC 9CGX 400100 05 Ser.N .123000001

AC 400V 3N

50Hz

Power Boiler

16500w

Power Tank

7500w

Power Max

26800w

Made in EEC

Model RT10 ED

PNC

9CGX400100 05

Ser.N .123000001

•

Make four ø 9mm though holes in the support, res-

pecting distances given in Figure 7.

Figure 7

Place the dishwasher on the support, matching the

holes just made with the seats of the feet in the

bottom of the machine (Figure 8).

Secure the dishwasher with M8 screws.

Figure 8

Connect the appliance water supply pipe "A"

(Figure 4) to the mains, fitting a cut-off valve, the fil-

ter provided and a pressure gauge between the

appliance and the mains (Figure 9).

In NUC1G / EUC1G models, connect the double

non-return valve "B" (Figure 9) supplied and the

machine supply pipe.

Figure 9

Check that the dynamic water supply pressure,

measured between the appliance and the main, is

between 200 and 300 kPa for machines with pres-

sure boiler and between 50 and 700 kPa for

machines with atmospheric boiler (test while dish-

washer tank or boiler is filling with water).

If the pressure is too high, fit a suitable pres-

sure reducer on the inlet pipe.

431 mm