Anderson 80G800 Panduan Pengoperasian - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pembakar Anderson 80G800. Anderson 80G800 17 halaman.
Anderson Thermal Solutions – SSA80 Operation Manual
This manual has been written for those who are already familiar with all aspects of nozzle
mix burner and its add-on components. Main contents of the manual including safety rules,
burner
installation,
commissioning,
operation
parameters,
maintenance
and
troubleshooting, spare parts, etc.
1. Disclaimer Notice
Anderson Thermal Solutions (Suzhou) Co., Ltd. reserves the right to change the
construction and/or configuation of our product at any time without informing customers.
If the product or its individual modules are used for purposes other than the designated
purpose, their effectiveness and suitability must be confirmed.
Anderson warrants that the product itself will not infringe any patents. Every effort has
been made to make this manual as accurate and complete as possible. If you find errors or
omissions, please contact us so we can correct
them.
2. Liability and Warranty
Due to negligence, breach of warranty or other reasons, Anderson's liability for its products
is limited to the provision of such replacement parts and will not be liable for any other
injury, loss or expense, whether direct or indirect, including but not limited to Loss of or
damage to the use of materials that sell, install, use, fail to use or repair or replace Anderson
related products.
The warranty is void if: any operation explicitly prohibited in this manual, any adjustment
or assembly process not recommended or authorized.
3. Safety Guide
Only those who were trained and qualified person can follow the manual to operate or
adjust the combustion system. The fire was prohibited within a radius of 5 meters of the
combustion system. Flame, non–covered light sources or heat sources shall not be brought
to the combustion area unless it is related to the process. Welding in combustion control
area shall be approved to ensure the safety in the area and also preventive measures
should be taken into consideration.
Before starting, the operator must confirm whether the burner and gas pipeline are in
normal working condition, and there is no flammable substance around the burner. The
burner must be operated with fuel and oxygen or air. The ignition and operation of the
burner must be performed at the specified position. The burner has been correctly and
safely installed before ignition. The ignition of the burner needs to be performed after the
Anderson Thermal Soluions(Suzhou)Co., Ltd
1