DREAMS SANA Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Perabotan Dalam Ruangan DREAMS SANA. DREAMS SANA 8 halaman. Storage bed

Fitting Cross Bar - Use Pack 'B'

Stage

HEADBOARD END

NOTE: IT IS VERY IMPORTANT

THAT THIS CROSS-BAR IS FITTED TO

MAINTAIN THE STRENGTH OF THE FRAME

Fitting Slat Frame - Use Pack 'B'

Stage

Carefully lay frame down. Make sure there is an even

gap each side of about 10mm, as in the sketch.

Hold frame then tighten all six bolt sets 100% using spanner (I) & Allen key (D).

LABEL

CROSS BAR FITS HERE

Carefully hold cross bar (7) in position under the first set of holes in

the support bars.

The holes to use for cross bar are clearly labeled - look carefully at the

drawing. Note that the cross bar must be fitted in this position

otherwise the gas lift cylinders will be damaged.

Using last two bolt sets (F), (C), (B) & (G) loosely clamp cross bar

to underside of the slat frame support bars.

Page 7 of 8