Atkinson Electronics A0217 Manual - Halaman 13

Jelajahi secara online atau unduh pdf Manual untuk Unit Kontrol Atkinson Electronics A0217. Atkinson Electronics A0217 16 halaman. Generator start control module

Halaman Cetak

Diesel Generators

The diesel generator is started by the GSCM in either automatic or manual mode. A field installed relay that will handle the

glow plug current is needed if not already installed on the engine. A fuel control solenoid is connected to the K3 (ignition)

relay terminals. decompression solenoid furnished with the generator must be wired to K4 (shutdown) relay to energize on

shutdown.

Automatic Generator Powered AC Pump

In this application the GSCM is connected to a pressure or level switch into the battery sense terminals. To make the

appropriate cut-in and cut-out adjustments. See AUTOMATIC STARTING FOR BATTERY CHARGING section: 9. The cut-in and

cut-out adjustments must be set at the maximum for the switched input auto start mode to operate. See AUTOMATIC

STARTING FOR BATTERY CHARGING section: 9 & 4:9. The K5 (load) relay energizes the pump contactor.

www.atkinsonelectronics.com

800.261.3602

Circuit Board Division

Revised 09/18