ATL ATU Telex Unit Panduan Pengoperasian dan Pemasangan - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Pemasangan untuk Modem ATL ATU Telex Unit. ATL ATU Telex Unit 16 halaman.

The Generic option is an unsupported choice. It is provided to allow

users the option of attaching a printer of their own choice.

Printer Speed (H)

Shows the speed of the printer interface.

Printer Data Bits (I)

Shows the number of bits in a byte over the printer interface.

Printer Stop Bits (J)

Shows the number of stop bits in a byte over the printer interface.

Printer Parity (K)

Shows the parity of each data byte over the printer interface.

Printer Flow Control (L)

Shows the flow control being used by the printer.

Go ahead on Buffer Empty (M)

Computers that send data in blocks use this option. After a Block has

been used up (i.e. the buffer is empty) the Telex Unit sends a Go Ahead

(SO) to the Host.

Printer Compulsory (R)

This option indicates whether the presence of the printer overrides

Host security such that continued acceptance of incoming calls is

permitted when the host computer is in fault condition.

Drop Carrier on Line Closed (S)

This option controls the state of the carrier presented to the telex line

under a Closed Line condition. The default value leaves the carrier

enabled in a Closed Line condition.

Automatic Reset (T)

The default value for this option means that a soft reset command,

(ESC) A, is required to put the unit into idle state from a power up

state. This is the normal operation of the telex unit when driven by

most applications. By enabling this option, the telex unit goes directly

on line without requiring a reset command.

Previous Line (X)

Used when in prompted mode for displaying the previous

configuration parameter.