ATLANTIC LIGHTING Commercial Series Petunjuk Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Peralatan Pencahayaan ATLANTIC LIGHTING Commercial Series. ATLANTIC LIGHTING Commercial Series 4 halaman. 4'' trimless led

Halaman Cetak

As seen in Fig. 1 and 2, extend the hanger bars until they meet the ceiling joist. Frame to be install flush to the top side of ceiling

material. Drive in the self fastener at the end of the hanger bar. Then for a more permanent fastener install a screw or a nail using

the holes provided. For installation of this fixture in a grid or drop ceiling refer to Figures 3 and 4 below.

Frame must be rigid and not allow the fixture to lift while reflector is being installed.

Remove the junction box cover and wire in fixture per your local codes. When wiring is complete make sure to attach the junction

box cover securely with the attached clip.

LED module should be protected from dust or paint during the ceiling installation process.

After the ceiling is installed, the reflector is to be secured to the LED module and inserted into the ceiling opening. Remove any

protective covering from the LED module and position the module on top of the reflector clips with reflector screws accesible.

(as shown in Fig1.A ) Align the key-slots in the reflector over the two reflector screws on the LED module and tighten the screws to

secure. Push reflector up into the ceiling opening untill flange is flush against the ceiling.

5. IMPORTANT: THIS FIXTURE MAY BE EQUIPPED WITH A VOLTAGE SPECIFIC THERMAL DEVICE AND MAY ONLY BE

WIRED ACCORDING TO THE VOLTAGE THAT WAS ORDERED. DO NOT CHANGE THE VOLTAGE SPECIFIED.

REFERENCE EXAMPLE: Model No. COM4-SYL30-35K-1 (or) Model No. COM4-SYL30-35K-2

Dimming: Reference our website atlantic-lighting.com/main/support for compatible dimmers for the standard

0-10VDC driver or optional drivers.

The standard hanger bars supplied with the housing has a notch cut out of the bottom so it can sit on top of the T-grid then simply attach

a wire with the holes provided as shown in Fig. 4.

The other option is using a set of 517 Caddy bars or equal

which are designed to snap onto the top of the T-bar for quick

installation as shown in Fig. 5.

01/31/20

LED_Install_Sheet_4_Comm_SYL_013120.pdf

WARNING

Risk of Electrical Shock

Disconnect power from circuit breaker or

fuse before installing or servicing any light fixture.

Fig. 1

T-Grid or Drop Ceiling Installation

Wire (by others) is not necessary and is optional (check your local codes).

508 678-5411 |

508 678-5408

REfLECtoR SCREwS

Fig.1.

120 VOLT

Fig. 3

www.atlantic-lighting.com

LED Commercial Series,

Installation Instructions

Fig. 2

277 VOLT

Fig. 4

4" & 5"

Page 1