Atlas DPA-102PM Panduan Pemilik - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Atlas DPA-102PM. Atlas DPA-102PM 20 halaman. Networkable 2-channel power amplifier with dsp
Halaman Cetak
DPA-102PM - Networkable 2-Channel
Power Amplifier with DSP
II. Internet Web Browser
This method is very similar to the Direct Connection method covered in Section 1, but using a web browser on your local network to
find the DPA amp.
1. Connect the DPA amplifier using a standard Ethernet cable to a Router.
Make sure the Router is set to DHCP mode.
2. Connect the computer to the network via the same router or using Wi-Fi..
3. Open a web browser on the computer, Google Chrome and Mozilla Firefox are the recommended browsers for use with DPA
amplifiers.
4. In the web browser address bar, type in the following: "http://dpa102pm and hit enter.
This example uses the DPA amplifier model DPA-102PM.
5. Out of the box all that is needed to connect to the amplifier is the amplifier's model number which is not case sensitive.
Note: after you have connected you can change the name of the amplifier to meet your install's naming orientation.
6. The amplifier will be discovered and the DPA Control Page will launch after pressing the "Enter" key.
A example of the GUI web page is shown in Figure 2.
7. The DPA amplifiers IP address can be directly entered into the
Web Browser to access the DPA GUI.
Example: "http://192.168.1.110"
III. Atlas Sound IP Discovery Software
This method is the easiest way to find and connect to any DPA
Amplifiers on the network. The Atlas IP Discovery Software only
works with Windows
®
1. Download the DPA amplifier IP Discovery software from
http://www.atlassound.com/dpa
2. The DPA Amplifier Software is a small zip file that must
remain a zip file because it has an execution (.exe) file that
launches the software. Most Internet security software
will block .exe files unless they are in zip file format. Also
download the DPA amplifier IP Discovery Software installation
guide to assist with setup.
Atlas DPA IP Discovery Software ICON
Figure 3
IV. Smartphone or Tablet (Wi-Fi)
1. DPA amplifiers can be accessed remotely using a smartphone or tablet device using the IP address for the amplifier being
accessed. Use method 1, 2, or 3 to create the initial DSP configurations and then access the amplifiers using the mobile device
interface.
2. To access a DPA amplifier on a network using a smartphone or tablet requires that the smartphone or tablet be able to access the
same network via Wi-Fi.
3. Open the Smartphone's or Tablet's Internet Browser and enter the IP address in the address bar.
Example: "192.168.1.110/mt1.html"
Note: Some Network Firewall may block access. If this occurs consult an IT technician for firewall setting adjustment.
AtlasSound.com
based computers.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Specifications are subject to change without notice.
Telephone: 800.876.3333 • Fax: 800.765.3435
– 12 –
Owner's Manual
Figure 2