Bose 802 C II Panduan Pemilik - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pembicara Bose 802 C II. Bose 802 C II 22 halaman. System controllers
Juga untuk Bose 802 C II: Panduan Servis (20 halaman), Panduan Servis (23 halaman)

Halaman Cetak

A.2 Connecting The oC-1 To The

systems Controller

The rear panel of the systems controller should face

you. The internal harness should be inside.

1. Turn the OC- circuit board so the component

side faces you.

2. Insert the small white connector on the

internal harness into the J jack on the circuit

board (Figure 6). Match the fin on top of the

connector to the slot on top of the jack.

Connecting the OC- circuit board to the systems controller.

Seat the OC- plugs into the receptacles inside the systems controller.

3. Insert the circuit board into the multipin

receptacles inside the systems controller (Figure

). The component side faces you. The J jack

is on the left side. Press gently to seat both plugs

firmly in the receptacles. Do not force.

NOTE: If you install the OC- backwards it won't fit

properly and the interior harness won't reach the jack.

4. Replace the controller cover. Slide the lip on the

front edge of the cover under the controller front

panel.

5. Replace the four screws in the controller cover.

Tighten firmly.

Figure 26

Figure 27