Atlas Copco PBE 6 S Petunjuk Perbaikan - Halaman 4
Jelajahi secara online atau unduh pdf Petunjuk Perbaikan untuk Bor Atlas Copco PBE 6 S. Atlas Copco PBE 6 S 11 halaman.
Halaman Cetak
1
Detaching the
Loosen the two short (A) and the two
armature
long (D) screws.
2
Remove the motor housing (9) with the
field (1) and the air deflector ring (2).
3
Remove the air deflector ring (2) from the
motor housing (9) and expel the field (1)
from the motor housing (9).
4
Loosen the screws (B). Remove the brush
holders (C) from the motor housing (9).
5
Pull out the complete armature by turning
it. If necessary, hit the motor housing light-
ly with a plastic hammer for support.
6
Remove the bearing sleeve (3) from the
armature bearing (4).
7
Press off the armature bearings (4)
and (8) with aid of the forcing disks
(service tool).
8
Remove the insulating disk (5) and the
ring (7).
1
Dismantling the
Peel off the ring (4) and remove the plastic
spindle
housing (5).
2
Remove the four balls (3) with aid of a
magnet.
3
Loosen the five screws (1) of the adapter
sleeve (2) and remove the adapter
sleeve (2). If necessary, use a plastic
hammer for support.
4
Remove the tool reception (8) completely
with the snap die (D), the spacer (7) and
the O-ring (6). Knock out the spacer (7)
through the grooves (E) with aid of a man-
drel.
5
Remove the snap die (D) from the tool re-
ception (8).
6
Remove the following parts:
grease seal (C),
spacer (B),
recoil ring (A) and
rubber ring (9).
Repair Instructions No.182.03/98
h
i
j
k
4
5
3
2
1
PBE 6 S
8
7
6
5
4
3
C
2
1
D
C
6
7
8
E
A
9
D
C
B
PAGE
3
5
9
A
B
6