Atlas Copco PH 38 Petunjuk Perbaikan - Halaman 2
Jelajahi secara online atau unduh pdf Petunjuk Perbaikan untuk Bor Atlas Copco PH 38. Atlas Copco PH 38 8 halaman.
Special Tools
Pressing-in tool
Required
Assembly tip
Assembly cone
Assembly cone
Assembly and
disassembly sleeve
Important!
Before beginning the maintenance work, perform an initial check with a high voltage test according
to VDE (see chapter Electrical and Mechanical Test Instructions).
Before all repair work, pull the power plug from the socket!
Disassembly
1
Dismantling the
Fix the machine vertically in a holding
nosepiece
device.
2
Loosen the Allan screws (3) and remove
the nosepiece (1).
3
Remove the disk springs and the two
washers.
4
Remove the bearing end plate (2). If
necessary, hit it lightly with a plastic
hammer.
1
Dismantling the
Remove the washer (3) as well as the O-
intermediate gear
ring.
2
To expel the snap die (2) lightly hit the
housing with a plastic hammer.
3
Remove the intermediate gear (1)
together with the disk.
4
Remove the pins (4).
Repair Instructions No. 162.11/95
PHD 26/ PH(D) 38/ PH 240 D/ PH 350 (D)
276 8000
283 5000
283 1000 (PH 350 (D)/ PH (D) 38)
283 1100 (PH 240 D/ PHD 26)
283 4600
1
3
1
2
3
PAGE
1
2
1
2
4