Alert-it Care Systems P163BCA Buku Pegangan - Halaman 6

Jelajahi secara online atau unduh pdf Buku Pegangan untuk Sistem Keamanan Alert-it Care Systems P163BCA. Alert-it Care Systems P163BCA 12 halaman.

Battery Replacement

Expected Battery Life: Operating Mode

No failsafe heartbeat, no alarms

Fail safe heartbeat, and alarms

Maximum alarm number (based on 2 min response)

The battery needs replacing when FAULT 30 or 31 shows on the P137/8 pager

(and the alarm led flashes intermittently every 8 seconds). The P163 will continue

to function for some hours, allowing time for this replacement. If the battery is

exhausted then the P163 will click continuously without the light flashing or

transmitting.

The battery check is automatic in Securelink mode, or stimulated by making a short

press of the RESET button. This should be done daily to test the battery. The

batteries are found inside the compartment via the sliding door on the base (see

page

)

Battery Type: 2 of AA Alkaline Batteries or equivalent

Cleaning:

The following is a general guide line based on the components listed on page 3. Where a

different sensor has been supplied, then please refer to the cleaning instructions supplied

with that sensor.

Technique A

Wetting with strong disinfectant. This can include immersion provided plugs and any

obvious breathing holes are avoided.

Technique B

Wiping with cotton wool pads moistened (compressed until dripping stops) with a

mild detergent (0.5% washing up liquid) solution.

Technique C

Wiping with disposable 70% isopropyl alcohol wipes. Ensure that any plugs are

completely dry before reinserting into the sensor input socket on the monitor.

Technique D

Full immersion in detergent , water and optional disinfectant. See component

washing instructions for details

UH1142 P163 General Interface page 6 of 8

Maintenance

Battery capacity

1 year

6 months

2000 alarms