ansio 5012 Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Ketel ansio 5012. ansio 5012 8 halaman.

OPERATION OF YOUR KETTLE

• To fill the kettle, remove it from the power base and open the lid by

pressing the open lid button. Fill in with the desired amount of water, and

then close the lid. The water level should not exceed the max mark (1.7

L) or be below min level (0.6 L) as shown in the image on Page 4. Too

little water will result in the kettle switching off before the water has been

boiled.

NOTE: Do not fill the water over the maximum level, as water may spill out

of the spout when boiling. Ensure that the lid is firmly closed before plugging

the power outlet.

• Position the kettle on the power base.

• Connect the plug into a power outlet. Press the switch down. The

indicator will light up and the kettle will start to boil the water. The kettle

will switch off automatically once the water has boiled. You may also

switch off the kettle manually by moving the switch button up.

NOTE: Ensure that the switch is free of obstructions and that the lid is firmly

closed. The kettle will not turn off if the switch is constrained or if the lid is

open.

• Lift the kettle from the power base and then pour the water into a desired

container.

NOTE: Operate carefully when pouring the water from your kettle, as boiling

water will scald.

• The kettle will not re-boil until the switch is pressed again. The kettle may

be stored on the power base when not in use.

NOTE: Unplug the kettle from the power outlet when not in use.

Customer Support – 0800 080 6781 (UK Toll Free) or +44 207 157 9795

ANSIO 5005 | 5012 (J21v01)