Attic Breeze AB-4062 Panduan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Kipas angin Attic Breeze AB-4062. Attic Breeze AB-4062 2 halaman. Wall mount solar fan

Halaman Cetak

Building the Mounting Box

Begin by building a mounting box for the fan unit. The

mounting box may be constructed from 2x4 boards for

wood frame structures or a prefabricated sheet metal

mounting box may be used for commercial applications.

The mounting box must accept an 18"x18" square housing

and allow the wall mount fan to extend roughly 11" to the

inside of the structure from the mounting surface.

For wood frame structures, use a reciprocating saw to cut

the wall vent hole roughly 1" larger on all sides than the

mounting box. This will allow room for securing the fan

unit to the mounting box surface. For commercial

applications, the size of the wall vent hole will depend on

the dimensions of the prefabricated mounting box.

NOTE: DO NOT CUT THROUGH ANY STRUCTRUAL SUPPORT MEMBERS WHEN INSTALLING

THE MOUNTING BOX. If the location where you wish to install the wall mount fan uses 16" on

center support studs, a framing cripple will be required. Consult a local contractor for assistance

with proper design and construction of your mounting box if needed.

Installing the Fan Unit

Next, install the Attic Breeze wall mount fan flush to the

mounting box (see Figure 3). Secure the fan unit to the

mounting box with self tapping screws. Flash,

weatherproof, and trim around the fan installation as

appropriate for the specific exterior of your structure.

Routing the Power Cable

Locate the power cable include with your Attic Breeze

solar attic fan. Make sure the power cable is long enough

to reach the location where the remote solar panel will be

installed.

NOTE: If additional power cable length is needed for your

installation, Attic Breeze offers a 40 foot extended

power cable as an available option.

Next, plug the power cable into the power cable connector located on the fan unit. If installing a Breeze

Mate

control system, first plug the Breeze Mate

the power cable into the Breeze Mate

NOTE: If installing a 40W solar attic fan, plug the power cable splitter into the power cable connector

located on the fan unit and then connect the two power cables to the splitter. For Breeze Mate

installations, the power cable splitter must be plugged into the Breeze Mate

Route the power cable through the attic, starting from the fan unit to the location where your remote solar

panel will be installed. Secure the power cable in place. The power cable may be routed out of the attic by

bringing the cable through an existing passive vent, penetrating a gable wall and running the cable along the

roof eve, or simply routing the power cable directly through the roof. When making any wall or roof

penetration, caulk around the penetration using a roof-grade weatherproof sealant.

Solar Panel Mounting

Install the solar panel mounting brackets per the instructions included with your specific Attic Breeze bracket

kit. Plug in the power cord to the connector on back of the remote solar panel. Securely mount the solar

panel as required to your roof or structure.

cable into the fan's control cable connector, and then plug

controller per the instructions included with that product.

www.atticbreeze.net

Figure 2 - Building the Mounting Box

Figure 3 - Mounting the Fan Unit

controller.