AddEnergie SmartTWO Panduan Instalasi - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pengisi Daya Baterai AddEnergie SmartTWO. AddEnergie SmartTWO 20 halaman.
Juga untuk AddEnergie SmartTWO: Panduan Memulai Cepat (4 halaman)

Halaman Cetak
Preliminary Tests & Commissioning
2
2
3
1
2
1
201304-AAA-001
201304-AAA-001
2
2
3
1
© 2019 ADDÉNERGIE TECHNOLOGIES INC. ALL RIGHTS RESERVED Information and specifications contained in this document are subject to change, amendments and additions at any time, without notice
Instructions:
1.
Place the charging port in the holder and close the door.
2.
Once the charging station is powered up, check the following:
2.1. The door is locked.
2.2. The charger head status lights turn to GREEN.
2.3. The display shows the greeting messages.
3
1
3.
Swipe the card provided with the charger in front of the
2
3
display.
The charger will react as follows:
3
1
3.1. Once the reader detects the card, it will emit an audible
beep.
3.2. The access card is authenticated by the charging station.
3.3. If the test is successul, the charger head status WHITE
lights will start flashing and the charging port will be
unlocked.
3.4. If the charging port is inserted into an Electrical Vehicle,
it will begin charging. If not, 1 minute later, the charging
session will be cancelled.
4.
If the preliminary test is successful:
4.1. Make sure you have installed the Communication
Gateway according to the instructions described in the
"Important" section, on page 2 of this guide.
4.2. Call AddEnergie for charger commissioning:
3
1
2
3
1
2
3
1
2
4
877-505-2674
2
3
1
2
3
1
2
3
3
1
4
1
19