Atwood MHL2242 Pengoperasian & Pemeliharaan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Pengoperasian & Pemeliharaan Instalasi untuk Tangga Atwood MHL2242. Atwood MHL2242 5 halaman. Bunk ladder for recreational vehicle bunk bed

Halaman Cetak

Before you begin...

MAY CAUSE PERSONAL INJURY OR PROPERTY

DAMAGE

It is the responsibility of the installer to inspect that the

permanently mounted RV bunk bedrail condition,

installation, and rated capacity will allow the use of this

Bunk Ladder. Seek a qualified technician to determine

if your permanently mounted RV bunk bedrail is

installed properly and is fit for use with this Bunk

Ladder.

-The Bunk Ladder is designed for use with a bunk

bedrail of a common design not more than 2" thick and

with a top height of at least 3".

-The bunk bedrail should be of a structural design that

allows loading in all directions under the specified

capacity.

-The bunk bedrail should be securely mounted.

-The bunk bedrail should have a minimum rated capacity

compatible with the rating of the Bunk Ladder.

-The bunk bedrail should be in good condition with no

dented, cracked or damaged parts.

INSTALLATION

How to mount the Bunk Ladder to your permanently-

bunk bedrail.

MAY CAUSE PERSONAL INJURY OR DEATH

The Bunk Ladder is not intended to be a permanent

fixture. The Bunk Ladder should only be applied when

the vehicle is parked on level ground. Remove and

safely store the Bunk Ladder before starting or moving

the vehicle.

1. Make sure your ladder is in the correct orientation

prior to installing. Standing in front of the ladder with the

rubber feet of the bunk ladder setting on the floor, the

lowest portion of the ladder should be vertical and the

center section of the ladder should angle away from you.

This is the install orientation.

CAUTION

WARNING

2. The mounting brackets are rotated for shipping

purposes.

You may need to rotate the mounting

brackets prior to installing. Holding the ladder in the

install orientation, turn the mounting brackets on top of

the ladder until they are facing straight away from you.

Retighten the attachment screws to secure the mounting

brackets in the install orientation, as they may have

loosened during this exercise.

3. Your bunk ladder is designed with an optimal center

angle of 9° and must be installed so that the ladder

center angle is no more than 11° from vertical. Your

bunk ladder mounting height will be determined by

choosing a bunk rail that allows the ladder to satisfy

these angle requirements. With the legs resting on the

floor, the range of horizontal distance from the bunk rail

to the ladder feet should be as listed in the following

diagram: