Aolait AL350RX Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Pencahayaan Aolait AL350RX. Aolait AL350RX 17 halaman.

PROTECTION FROM ELECTRIC SHOCK

• Disconnect the fixture from AC power before removing or installing any cover or part and when not in

use.

• Always ground (earth) the fixture electrically.

• Use only a source of AC power that complies with local building and electrical codes and has both

overload and ground-fault (earth-fault) protection.

• Before using the fixture, check that all power distribution equipment and cables are in perfect condition

and rated for the current requirements of all connected devices.

• Power input and throughput cables must be rated 20 A minimum, have three conductors 1.5 mm²

(16 AWG) minimum conductor size and an outer cable diameter of 5 - 15 mm (0.2 - 0.6 in.). Cables must

be hard usage type (SJT or equivalent) and heat-resistant to 90° C (194° F) minimum. In the EU the

Cable must be HAR approved or equivalent.

• Use only Neutrik Powercon NAC3FCA cable connectors to connect to power input sockets. Use only

Neutrik Powercon NAC3FCB cable connectors to connect to power throughput sockets.

• Isolate the fixture from power immediately if the power plug or any seal, cover, cable, or other

Component is damaged, defective, deformed, wet or showing signs of overheating. Do not reapply

power until repairs have been completed.

• Do not expose the fixture to rain or moisture.

PROTECTION FROM BURNS AND FIRE

• Do not operate the fixture if the ambient temperature (Ta) exceeds 40° C (104° F).

• The exterior of the fixture becomes hot during use. Avoid contact by persons and materials. Allow

the fixture to cool for at least 10 minutes before handling.

• Keep all combustible materials (e.g. fabric, wood, paper) at least 100 mm (3.9 in.) away from the

fixture.

• Keep flammable materials well away from the fixture.

• Ensure that there is free and unobstructed airflow around the fixture.

• Do not expose the front glass to sunlight or other strong light sources from any angle.

• Do not illuminate surfaces within 200 mm (7.9 ins.) of this light.

• Do not attempt to bypass thermostatic switches or fuses.

• Do not stick filters, masks or other materials onto any optical component.

• Do not modify the fixture in any way not described in this manual