Daniels 844.BLU.PLOW Panduan Operator - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Operator untuk Peniup Salju Daniels 844.BLU.PLOW. Daniels 844.BLU.PLOW 16 halaman. 3-in-1 plow

PLOW INSTALLATION

3. Electric switch installation

harness has been pre assembled prior to shipping.

Prior to installing the electric wire harness and switch

by connecting the electrical connector plug to the

to the cab. Make sure the wire will not be pinched

when the plow is raised, lowered, or hydro turned.

Secure the wire with nylon zip ties as needed (Page

is not pulled or stretched during operation.

Use existing clamps along the boom arm or nylon zip

ties to secure the wire to the boom. Pay particular

lowered. Also, be sure to allow enough slack that

or movement between the machine body and the

electrical plug to the pre assembled plow harness at

installation process. Cover both connectors with

entering the electrical system.

Operator's Manual

a boot along the steering column, or through a hole

be drilled, select an area with no obstruction, on either

edges.

Install the black switch box in the cab. Install in a

that the switch box be mounted in a location which

machine. Use heavy duty two sided tape or a mounting

strap to mount the switch in the desired location.

to the installed switch. Keep the wire within the cab

routed behind the dash, wall, and door panels where

possible. Loose, exposed wire that is not properly

secured can be damaged or become tangled with the

white ground wire to a ground post or mounting screw

connectors are placed in a tool box or compartment

while the plow is installed on the machine. This will also

3-IN-1 PLOW