Audionet EPS Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Catu Daya Audionet EPS. Audionet EPS 13 halaman. Enhanced power supply
Juga untuk Audionet EPS: Panduan Pemilik (7 halaman)

Halaman Cetak

Installation and connection

Important

For connecting or removing the EPS to the mother unit, the EPS

and the mother unit must be switched off to prevent damage to

both devices.

Please make sure that all cables are in absolute best conditions!

Broken shields or shorted cables could damage both devices.

4.1 Placement

Important

Place the EPS right beside or at least 20 cm above/below of the

mother unit.

It is recommended to place the EPS into a high quality rack or onto a

stable table.

Do not expose the unit to direct sunlight.

Do not cover the ventilation slots.

Do not place the EPS in close range to heat sources like radiators.

Do not place the EPS on top of other units, especially not on top of

power amplifiers, pre amplifiers or similar that produce heat. Both

units could suffer damage from thermal overload.

Do not use the unit in places where it is exposed to vibrations.

Do not place the unit close to loudspeakers or into the corner of a

room where it is exposed to high levels of sonic energy, which might

reduce the sound quality of the unit.

4.2 Mains connection

The mains input 2

is on the back panel of the EPS. To connect the unit

to the mains use the included mains cord respectively the mains cord of

your mother unit with 7-pin connector (except MAP, MAP V2, MAP I),

see section 'Connecting the mother unit' on page 9.

If you prefer to use a different power cord make sure that it meets the speci-

fications for your home country

see numbers in section 'Overview back panel' on page 8.