Abus TVAC71070 Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem Keamanan Abus TVAC71070. Abus TVAC71070 14 halaman.
Juga untuk Abus TVAC71070: Panduan Cepat (4 halaman)

Halaman Cetak

Installation

1. Attach the illuminator mount to pan/tilt unit, wall or camera housing. Using

stainless steel fixings suitable for the relevant application.

2. Connect the lamp to a suitable (SELV) low voltage supply. Ensure that the

polarity is correct.

3. Commission the mains supply, camera and monitoring equipment.

4. Select the diffuser angle sheet required from the scope of delivery (if required).

To position the required diffuser sheet, insert the tool included in the slot at the

bottom of the cover and prise upwards slowly. Repeat at opposite end and

carefully remove cover. Remove backing sheet from the two adhesive discs

and secure required diffuser in position. Finally firmly clip the lens cover back

into place.

5. Adjust the pan angle of the illuminator to match the camera field of view.

6. Adjust the vertical alignment by loosening the side bolts (one on each side of

the main body) to maximise the results.

7. SLOWLY and GRADUALLY tilt the lamp upwards until the for part of the

required field of view is illuminated correctly on the monitor.

Connections

Remote Switching

The Illuminator may be activated remotely by a volt-free contact latched across the

telemetry wires (see Diagram above).

Photocell following contact

Volt-free relay contact-normally open (day) to normally closed (night). See Diagram

above.