Abus TVAC71070 Panduan Pengguna - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem Keamanan Abus TVAC71070. Abus TVAC71070 14 halaman.
Juga untuk Abus TVAC71070: Panduan Cepat (4 halaman)

Halaman Cetak

Trouble Shooting

Ensure all tests are undertaken by a qualified, trained engineer and ensure safe

working practices are followed at all times.

Step 1: Basics

• Check power connection

• Ensure power is 12-32V DC / 24V AC 50-60Hz

• Check the photocell is working - cover photocell ,light should turn on

• Ensure power supply is suitably rated to product - check the specifications

Step 2: Lamp Test

• Check current draw of lamp corresponds to specification

• Check current of lamp - see instructions for correct current settings

To check lamp current remove +ve (red) lead from power supply and connect a

multimetre (set to 10A) in line with the lamp. (One lead of multimeter in common

(COM) other lead into 10A socket of multimeter; set multimeter to read Amps).

Step 3: Set up camera, lens and illumination

• Check alignment of lamp

• Check camera lens- fully open at night and set correctly

• Check model number to performance specification to ensure required distance

is achievable

Step 4: Call for further assistance

If the lamp is still not delivering the required performance, please contact Technical

Support for further assistance

Note down:

• Model number and serial number of illuminator

• Camera make and model

• Ideally, provide images that illustrate the problem

Safety Warning

• When the lamp is running, it is hot to touch. before touching switch off the

illuminator and allow to cool for a minimum of 10 minutes.

• The illuminator should be positioned so that prolonged staring into the

illuminator at a distance closed than 1m is not expected.

• The light source of this illuminator is not replaceable, when the light source

reaches its end of life the whole illuminator should be replaced.

• If the flexible power cord of the illuminator is damaged it should be exclusively

replaced by a qualified, trained engineer.

• This equipment is not suitable for us in locations where children are likely to be

present.