Abus PLBW10000 Manual - Halaman 9

Jelajahi secara online atau unduh pdf Manual untuk Sensor Keamanan Abus PLBW10000. Abus PLBW10000 18 halaman. Dual motion detector
Juga untuk Abus PLBW10000: Panduan Cepat (2 halaman), Panduan Cepat (4 halaman)

Halaman Cetak

2.2. Planning, mounting and installation

The device uses low-power radio signals to communicate with the Z-Wave controller. To achieve the

best results, please note the following:



Please do not attach directly to metal planes or metal constructions, as this may limit the range.



The device has a radio range of up to 40 m.



The battery life of the device is reduced if the wireless connection to the Z-Wave controller is not

direct but via a repeater.

Test mode

Press the tamper switch 3 times in 1.5 seconds to activate the test mode. The test mode switches off

automatically after 10 minutes.

In test mode



the preset waiting time is ignored and several movement messages are also sent one after the

other without a reset.



Every 5 seconds a check is made to see if there is any movement. Accordingly, the LED lights

up when motion is present and a motion message is sent. If there is no movement, the reset

message is sent.

Use the test mode to select the optimal installation location.

Select installation location

The detector is only suitable for indoor installation.

When selecting a position for the detector, the following points should be observed:



Do not install the detector opposite a window or where it is exposed to direct sunlight. PIR

detectors are not suitable for use in conservatories due to the high temperature fluctuations.



Do not install the detector where it is exposed to fans or air conditioners.



Do not install the detector near a heat source (e.g. fire, radiator, boiler, etc.).



Do not mount the detector in a position where it is subject to excessive vibration.

Mounting instructions:

Sensitive

Insensitive

The detector is designed for mounting on a flat wall or

in a corner.

If possible, mount the detector in the corner of the

room so that the path of a person passes through the

detection

zone.

PIR

effectively to movement through the detection zone

than to movement towards the sensor.

English

detectors

respond