Apollo 1500 Panduan Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pembuka Gerbang Apollo 1500. Apollo 1500 17 halaman. Swing gate operator

STEP 2

Actuator Installation

1/2" x 3 1/2" Hex Bolt

1/2" Washer

1/2" Lock Nut

Do not over tighten nut

STEP 3

Mount the control box within 4 feet of the pivot arm.

Do not mount the control box where the person

using the push button on side of the box can

come in contact with the gate. Use mounting

hardware capable of supporting the weight of the

control box with the battery installed.

Set battery inside of control box with terminals

toward the front (Do not use any battery with side

terminals).

STEP 4

Connecting the Actuator (s)

Connect actuator cable to the "MASTER" connector on the

control board.

If a 1600 Dual Operator is being installed and conduit is

being used under the drive (recommended), cut the slave

(opposite side where control box is mounted) actuator cable

about 12" from the white connector. Run the remaining

cable across the drive through conduit and up through the

control box. Cutoff any excess cable and splice the short

piece back to the cable.* Connect to the "SLAVE" connector

on the control board.

Connect the RED power wire (s) to the battery positive ( + )

and the BLACK power wire (s) to the battery negative ( - )

* Instead of cutting the slave cable, remove the pins on the plug with a jeweler's common blade

screwdriver or appropriate tool (the staples on the actuator shipping carton work great) ,run the

cable through the conduit and reinsert the pins into the plug.

MASTER