Aponorm BASIS PLUS BLUETOOTH Petunjuk Penggunaan Manual - Halaman 9

Jelajahi secara online atau unduh pdf Petunjuk Penggunaan Manual untuk Monitor Tekanan Darah Aponorm BASIS PLUS BLUETOOTH. Aponorm BASIS PLUS BLUETOOTH 19 halaman.

Halaman Cetak

5. D uring the measurement, the "pulse rate

measurement active" icon

display.

T he result, comprising the systolic

diastolic

blood pressure and the pulse rate

per minute

is displayed.

W hen the monitor has finished measuring,

remove the cuff.

8. S witch off the monitor.

(The monitor does switch off automatically

after approx. 1 minute, though).



Y ou can stop the measurement at any time by

pressing the On/off button

uneasy or an unpleasant pressure sensation).



T his monitor is specially tested for use in

pregnancy and when suffering from pre-

eclampsia. When you detect unusually

high readings in pregnancy, take your blood

pressure again after a short while (approx.

1 hour). If the reading is still too high in the

repeat measurement, please contact your

doctor or gynaecologist.

Manual inflation

flashes in the

In case of very high systolic blood pressure (e. g.

exceeding 135 mmHg), it can be of use that you

and the

determine the pressure yourself. Press the On/

off button, after the monitor started inflating and

a pressure of approx. 30 mmHg appears in the

display. Keep the button pressed until the pressure

is about 40 mmHg above your average systolic

value – then release the button.

How not to store a reading

As soon as the result appears in the display, press

the On/off button

the MAM & time button

(e.g. if you feel



How do I evaluate my blood pressure?

The triangle at the left edge of the display

points at the range your blood pressure reading is

in. The reading is either in the optimum (green),

increased (yellow) or high (red) blood pressure ran-

ge. The classification corresponds to the following

ranges defined by international guidelines (ESH,

ESC, JSH) (values in mmHg).

and keep it pressed until «M»

flashes. flashes. Confirm the deletion by pressing

« CL» is shown after the reading was success-

fully deleted from the memory.