Elsema iS1500 Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembuka Gerbang Elsema iS1500. Elsema iS1500 8 halaman.

The limit sensor has a + marking indicating the centre of the sensor. Adjust the sensor

so that the + marking is the centre of the magnet on the gear rack.

The 2 x limit magnets should have different marking on them. One should have a

and the other should have a

same marking. The magnets can be installed on either side (open or close). Please see

the diagram below to locate the marking on the magnets.

When steel gear rack is used (or gear rack which are much slimmer), you will have to use

the packing block which comes with the limit switches. Please see the diagram below.

--+

Once the limit switches are adjusted turn the power on to the MCiS control card and follow on

screen instructions to profile the gate. The MCiS control card has been specially

configured to be used with iS1500 kit. For replacements please contact Elsema PTY.

. You cannot use the limit magnets if they have the

Polarity

Marking

Fig 6