AUSTRAMAC FLASHCUT 1400 RM Panduan Operator - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Operator untuk Melihat AUSTRAMAC FLASHCUT 1400 RM. AUSTRAMAC FLASHCUT 1400 RM 14 halaman. Diamond rock saw

Halaman Cetak

Ensure guard and mud flap are in position and in good condition.

Operator to work inside appropriately screened excavator, never

stand or operate saw in the same plane as the blade and always

stand at a safe distance from the saw (minimum 30m).

Rock saw to be checked every hour and after use for damage or lose

bolts.

Only use approved AUSTRAMAC blade designed for material being

10.

cut and the correct size for the rock saw (do not cut metal unless it is

imbedded in concrete).

Operator to observe blade at all times while cutting, if circular

11.

scratches are observed on boundary wall, or blade begins to wobble

cease cutting immediately and check bolts.

Never use a blade that is out of tension.

12.

Keep saw well clear of excavator and other persons.

13.

Once the cut is complete slowly raise the saw so that only

14.

approximately 100mm of blade is in the cut. Turn off oil and allow

blade to stop in cut. Remove saw from cut and place on stand.

Always turn off machine and remove key when getting out

15.

of the excavator or performing any maintenance or inspection.

Never apply lubricants or anti cease to bolts.

16.

Transport Handling and Storage:

It is essential that the rock saw is transported in a safe manner to ensure

the safety of other and that the machine is not damaged.

AUSTRAMAC supplied a stand and strap for the purpose of

transportation. The rock saw has a tag indicating the weight of the rock

saw and blade. The tag also indicates the weight of the saw, blade and

stand combined. Operators are responsible for ensuring that they safely

transport the rock saw. The rock saw is delivered fully assembled and

ready for use. Operators should consult AUSTRAMAC for guidance on

any repairs or maintenance.