Austroflamm SmartSpot Petunjuk Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Pengontrol Suhu Austroflamm SmartSpot. Austroflamm SmartSpot 14 halaman. Room temperature sensor
Juga untuk Austroflamm SmartSpot: Petunjuk Pengguna (20 halaman)

Halaman Cetak

6 | Connecting the SmartSpot sensor to the receiver

Connecting the SmartSpot sensor to the receiver

The SmartSpot receiver must be connected to the oven controls and supplied with power. (CHECK:

LED on the receiver is slowly flashing green.)

The SmartSpot sensor's batteries must be correctly inserted.

Establishing the connection takes approximately 30 seconds. When the connection is successful, the

LED on the receiver will be continuously lit green and the sensor will flash briefly every 3 minutes.

The temperature display and control will now work as they would with the wired temperature sensor.

Now briefly press the SmartSpot sensor's button marked

"1". The LED will now flash green.

Then press the "Setup" button on the receiver. The LED be-

gins to quickly flash green.

SmartSpot