Autani EnOcean Lembar Instalasi Cepat

Jelajahi secara online atau unduh pdf Lembar Instalasi Cepat untuk Aksesori Autani EnOcean. Autani EnOcean 2 halaman. Temperature and humidity combo sensor

Halaman Cetak
EnOcean Temperature and
Humidity Combo Sensor
Quick Installation Sheet
1
On the provided list of device serial numbers,
document the location for each Sensor.
sn:auxxxxxxxxx
EXAMPLE
EXAMPLE
Autani, LLC
|
7090 Columbia Gateway Drive, Suite 140
2
Installation
Handle the sensor housing
gently while dismantling the
sensor to avoid damaging
internal parts.
Use a 1/16" Allen Wrench to
removing the screws from the
bottom of the sensor housing.
Slightly open the bottom of the
sensor housing and then slide
up to disconnect from the top of
the base plate.
3
Pairing
Press the Learn Button on the sensor housing. If a message
is sent, the Red LED will flash on the sensor. If the Bridge
has received the message, its LED will briefly turn Green.
EÄO‘›ƒÄ, Temperature
Humidity Combo Sensor
LED
|
Columbia, MD 21046 USA
|
(443) 320-2233
|
www.autani.com
Color versions available @ autani.com
Dismantle
Bo om
Conec on
Moun ng
Sensor
Base
Housing
Plate
S c r
Screw
Allen Wrench
Base Plate
EÄO‘›ƒÄ, Temperature
Humidity Combo Sensor
Learn
Bu on
LED
________________________________________
EnOcean
Bridge
Pin
LED
Copyright Autani, LLC 2022. All rights reserved. For warranty and other legal information, go to www.autani.com/legal.
Document Number : 80286 | June 2022
4
Install the Sensor housing on top of the base
Moun ng
plate. Using a 1/16" Allen Wrench Install the
screws in base of the housing.
Hole
L L
W A
e w
Sensor
Housing
Moun ng Hole
Learn
Bu on
Pin
5
For further information, please refer to the
EnOcean Quick Start Guide available in the
autani website.
1
Assembly
Bo om
Conec on
Base
Plate
Screw
Allen Wrench
Continued.....