Gage Bilt GB722 Manual Petunjuk Asli - Halaman 9

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Peralatan Gage Bilt GB722. Gage Bilt GB722 20 halaman. Installation tool
Juga untuk Gage Bilt GB722: Panduan Instalasi (13 halaman), Manual Petunjuk Asli (20 halaman)

Halaman Cetak

WARNING:

Only qualified and trained operators shall install, adjust or use the assembly power tool for non-threaded

mechanical fasteners.

WARNING:

Operator

WARNING:

It is required that eye protection, hearing protection and safety boots be worn at all times while handling this

equipment.

WARNING:

The users or the user's employer must assess specific risks that could be present as a result after each use

based on their application.

●

Ensure there is adequate clearance for tool and operator's hands before proceeding. Keep fingers clear of any

moving parts. Keep fingers clear from fasteners and installed materials. Severe personal injury may result.

● Verify

●

Ensure that there are no electrical cables, gas pipes, etc., which can cause a hazard if damaged by the tool

WARNING:

Do not actuate fastener in the air. Personal injury from fastener ejecting may occur.

WARNING:

Air is exhausted from the bottom of the tool. Direct bottom of the tool (exhausted air) away from operator, other

persons working in the vicinity, foreign matter and liquid.

WARNING:

Do not carry from hoses or use as a hammer.

WARNING:

Do not use in explosive atmosphere.

WARNING:

Ensure air hose is securely connected to avoid possible hose whipping.

WARNING:

Always disconnect air supply when tool is not in use to prevent accidental start-up.

WARNING:

Ensure there is adequate clearance for tool and operator hands.

WARNING:

Incorrect stroke will damage the nose assembly.

WARNING:

Do not dry cycle or actuate tool without fastener in place. Damage to the nose assembly could occur.

CAUTION:

Do not use beyond the design intent.

GB722/568 INSTALATION TOOL

HOW TO USE THE GB722/568

MUST

read and understand all warnings and cautions.

the air lines and/or hydraulic hoses are not a trip hazard.

1. Insert pin into hole. Mate free-running nut with pin and

tighten finger tight to contact material.

NOTE: If the collar has only one tapered end, that

end MUST be out toward tool, not next to sheet.

2. Apply light torque to nut to draw sheets together and

remove looseness from joint. (See fastener specs for

torque values).

3. Place installation tool on nut. (Internal stop automatically

positions crimp jaws).

NOTE: Hold tool at right angle (90°) to work.

4. Actuate installation tool to press crimp jaws into nut,

then release actuator.

5. Remove installation tool from assembled fastener.

6. Use GO-NOGO inspection gages to assure proper

crimping. GO-NOGO gages are available to assure

proper crimping. Contact Gage Bilt for information.

7. Repeat steps 1-6.

KRIMPNUTS

11/21 REV. 5/22