Airwell-Fedders Remote Controller Panduan Ilustrasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Ilustrasi untuk Kontrol Jarak Jauh Airwell-Fedders Remote Controller. Airwell-Fedders Remote Controller 7 halaman. Room air conditioner

Halaman Cetak
Cooling/Heating/Fan only operation
Start
Ensure unit is plugged and power is available.
The OPERATION lamp on the display panel of
the indoor unit starts flashing.
1. Mode select button (MODE)
Press to select COOL, HEAT (Not applicable to
cooling only models), or FAN ONLY
2. TEMP/TIME button
Set the desired temperature, the most comfortable
4
temperature is between 21C /70F to 2 8C /82 F.
1
3
3. Fan speed button (FAN SPEED)
Press to select "AUTO" "LOW", "MED" and "HIGH"
2
4. ON/OFF button
When the remote controller is off, push this
button to start the air conditioner.
Stop
ON/OFF button
Push this button again to stop the air conditioner.
The FAN ONLY mode does not control temperature.
Therefore, perform only steps 1,3, and 4 to select
this mode.
DRYING OPERATION
Start
Ensure unit is plugged and power is available.
The OPERATION indicator on the display panel
of the indoor unit starts flashing.
1. Mode select button (MODE)
Press to select DRY.
2. TEMP/TIME button
Push the "TEMP/TIME" button to set the desired
temperature from 21 C/70F to 28 C/82F .
3
3. ON/OFF button
1
When the remote controller is off, push this
button to start the air conditioner.
2
Stop
ON/OFF button
Push this button again to stop the air conditioner.
Note: The fan speed cannot be adjusted when
the unit is in AUTO and DRY mode.
O
O
o
7
Handling the remote controller
CAUTIONS
.
The air conditioner will not operate if curtains, doors or other materials
.
block the signals from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose
.
the remote controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct
sunlight, the air conditioner may not function properly. Use curtains to
.
prevent the sunlight from falling on the receiver.
If other electrical appliances react to the remote controller. either move
these appliances or consult your local dealer.
O
.
Location of the remote controller.
Keep the remote controller where its
signals can reach the receiver of the
.
unit (a distance of 8m is allowed).
When you select the timer operation, the
remote controller automatically transmits
a signal to the indoor unit at the specified
time.
If you keep the remote controller in a
position that hinders proper signal
transmission, a time lag of up to 15
minutes may occur.
Replacing batteries
The remote controller uses two
dry batteries (R03/LR03X2)
(1) Slide the cover of the battery
compartment off according to the
arrow direction, then replace the
old batteries with new ones.
(2) Insert the new batteries making
sure that the(+) and (-) of battery
are installed correctly.
(3) Reattach the cover by sliding it
.
back into position.
After replacing batteries, set the
remote controller clock.
4