Great Land 1P61F Buku Petunjuk dan Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Buku Petunjuk dan Panduan Pengguna untuk Mesin Pemotong Rumput Great Land 1P61F. Great Land 1P61F 19 halaman.

Halaman Cetak
c) Remove the fillercap (1).
d) Using a clean funnel (2), fill tank to
approximately 5 mm below the inner
edge of the filler neck (3), being
careful not to spill fuel.
e) Tighten the fillercap (1) back and
clean any spilled fuel.
5.1.4 SPARK PLUG CAP
Fig. 5
Connect the cap (1) of cable to the
spark plug (2), making sure that there is
no grass or dirt either inside the cap or
on the spark plug terminal.
5.2 STARTING THE ENGINE
Refer to the manual of the device
on which this engine is installed in
order to understand how to start the
engine
5.3 USE OF THE ENGINE
IN OPERATION
WARNING
Keep your hands away from the
silencer
and
engine running, do not get loose-
fitting that can become extremely
hot. With the clothing (ties, scarves,
etc.) or hair doser to the top part of
the engine.
IMPORTANT
Do not operate on over 15° inclines
8
to prevent malfunctioning of the
GB
engine.
IM moteur 139 cc Outsourced texte-GB.indd 8
surrounding
areas
5.4 STOPPING THE ENGINE
Refer to the manual of the device
on which this engine is installed in
order to understand how to stop the
engine
5.5 CLEANING AND STORAGE
a) Do not spray with water or use
hydraulic lances to clean the exterior
of the engine.
b) Use an airgun (max 6 bar) making
sure that no grass debris and dust
fall inside the engine.
c) Store the lawnmower (and the engine)
in a dry place, sheltered from severe
weather conditions and sufficiently
ventilated.
5.6 LONG STORAGE
(OVER 30 DAYS)
In case the engine has to be stored for a
long time (for example at the end of the
season), a few precautions are needed
to help the future start-up.
a) Drain fuel from tank to prevent build-
ups inside the tank.
b) Remove the spark plug and pour
inside the spark plug hole about 3
cl of clean engine oil. Close the hole
with a cloth, then pull, slowly and
carefully, the starting rope so that,
with a few engine revolutions, the
oil will be distributed on the cylinder
inner walls. Reinstall the spark plug
without connecting the cable cap.
11/25/2014 2:35:24 PM