Gaggenau AW 210 Manual Petunjuk Pengoperasian dan Perakitan - Halaman 19

Jelajahi secara online atau unduh pdf Manual Petunjuk Pengoperasian dan Perakitan untuk Kap Ventilasi Gaggenau AW 210. Gaggenau AW 210 20 halaman.

Fig. 24

Fig. 25

For circulating air mode use the installation set

included with the ventilation ducts AD 010-112/122

und AD 011-112/122. You also need an activated

charcoal filter (KF 001-010).

Proceed as follows:

– Slightly loosen the screws of the retaining bracket

for the chimney paneling. Hang the angle pieces

onto the screws and tighten the screws.

– Screw the circulating air switch module to the

angle pieces (4 screws).

– Shorten the flexible air pipe accordingly. Fix the

flexible air pipe with hose clamps (Fig. 24).

– Establish the electrical connection.

– Stainless steel chimney only (AD 010-112/122):

pull the protective film off the chimney's trims.

Note: avoid damaging the sensitive metal surfaces.

– Fit the top chimney duct unit into the base. Make

sure that the fastening holes on the side are at the

top.

– Put both chimney duct units onto the hood.

– Pull the top chimney duct unit up into its final

position and secure it with 2 screws on the ceiling

holder (Fig. 25).

Note: avoid scratches when pulling the elements

apart by placing the assembly template, for

example, over the edge of the bottom chimney

paneling to protect it.

– Insert the activated charcoal filters.

– Insert the grease filters.