ADEMCO LYNX Manual Sistem - Halaman 11
Jelajahi secara online atau unduh pdf Manual Sistem untuk Sistem Keamanan ADEMCO LYNX. ADEMCO LYNX 14 halaman.
Juga untuk ADEMCO LYNX: Panduan Pengguna (17 halaman), Panduan Memulai Cepat (8 halaman)
Halaman Cetak
Ademco Lynx System Manual
If the Paging feature has been programmed for your system, your pager will respond to certain
conditions as they occur in your system by displaying a message that indicates the type of condition that
has occurred. The message appears in a 7-digit format explained below. The system can also be
programmed to send up to 16 additional digits that will appear in front of the 7-digit message. These 16
digits may consist of a PIN number or special digits needed by the pager, account number, pauses, or any
other special characters you may choose (for example, you may want to use a special character code to
distinguish between security system messages and usual pager messages). See your installer if these
additional characters are desired.
Code Format
The Pager Code takes the following form:
(AAAAAAAAAAAAAAAA) EEE-00NN
AAA... = Optional 16 digits, programmed by your installer.
EEE = 3-digit number describing the event that has occurred, as follows:
911 = Alarm (00NN following indicates the zone that caused the alarm)
101 = Open, system disarmed (00NN following indicates user number)
102 = Close, system armed (00NN following indicates user number)
811 = Trouble (00NN following indicates the zone that caused the trouble)
00NN = First two digits are always 00, followed by 2-digit user or zone number, depending on the type of
event that occurred. If NN = 00, it can mean an AC loss has occurred, the system battery is low, or a
5827/5827BD wireless keypad battery is low. The Master Keypad will indicate the specific condition.
Manual Paging
In addition, your system may have been programmed to send a unique pager message when the AUX key
is pressed. The actual message sent is 999-9999 (the hyphen may not appear, depending on your pager
service). This code can be used to alert the person with the pager to whatever meaning you pre-arrange
(e.g., "call home"). Ask your installer if this has been done for your system.
To manually send the pager message, if programmed, hold [AUX] until 4 beeps sound.
Remote Control Feature
The ADT Ademco Lynx Security System is equipped with a remote interactive phone capability that
permits access to the security system fro many off-site touch tone telephone using all user codes. If this
http://alpha.adt.com/help/261[11/14/2018 8:02:22 PM]