AFG 1.0AT Panduan Pengguna - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Treadmill AFG 1.0AT. AFG 1.0AT 17 halaman. Afg series
Halaman Cetak
AS SE MB LY ST EP
HARDWARE BAG CONTENTS :
LEFT CONSOLE MAST
A
Open HARDWARE BAG .
B
With running deck in lowered position, place CONSOLE on upright masts. Align the
brackets that are underneath the console with the holes of the upright masts.
C
To assemble the LEFT CONSOLE MAST to the CONSOLE, insert 1 BOLT (G) into the hole in
the LEFT CONSOLE MAST and lightly tighten.
D
Gently lift RIGHT side of the CONSOLE to connect the CONSOLE CABLE. Carefully tuck wires
in mast to avoid damage. NOTE: Do not pinch console cable wires.
E
Repeat STEP C above to attach the RIGHT CONSOLE MAST to the CONSOLE.
F
Tighten console bolts completely.
G
Fit PLUGS (H) over each BOLT (G) head after tightening.
10
1.0AT_Rev.1.2.indd 10-11
BOLT (G)
PLUGS (H)
50 mm
Qty: 2
Qty: 2
PLUGS (H)
BOLTS (G)
CONSOLE
* NOTE: Be
careful not to
DO NOT ATTACH
pinch any
THIS SIDE UNTIL STEP 3-D
wires while
CONSOLE CABLE
attaching the
console.
RIGHT CONSOLE MAST
ASSEMBLY STEP
HARDWARE BAG CONTENTS :
BOLT (I)
90 mm
Qty: 2
BOLT (I)
ARC WASHER (J)
A
Open HARDWARE BAG .
B
Align SUPPORT BAR with holes in CONSOLE MASTS.
C
Insert BOLTS (I) and ARC WASHERS (J) into holes of the SUPPORT BAR.
NOTE: Look into holes in the right mast before inserting bolts to avoid pinching cables.
D
Tighten support bar bolts completely.
POWER SWITCH
CIRCUIT BREAKER
YOU'RE FINISHED!
ARC WASHER (J)
17 mm
Qty: 2
CONSOLE
BOLT (I)
ARC WASHER (J)
SUPPORT BAR
CONSOLE MASTS
Connect power plug to the treadmill
and connect the cord to a power
outlet. The on/off switch is located
next to the power cord. Flip this
switch to the 'ON' position, so that
the switch is lit. You will hear a
beep and the console will light up.
11
7/23/07 10:47:14 AM