GREAT PLANES Wright Flyer Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan GREAT PLANES Wright Flyer. GREAT PLANES Wright Flyer 16 halaman. Almost ready to fly electric powered r/c airplane

Halaman Cetak

BUILDING INSTRUCTIONS

Install the Bottom Wing

1. The above photo shows the bottom of the bottom

wing. Install a nylon control horn on the bottom of the right

aileron with two 2-56 x 3/8" [9.6mm] machine screws and

the nylon backplate. Do not tighten the screws too much.

The holes in the control horn for the clevis should face

forward. Do not install a control horn on the left aileron until

instructed to do so.

2. The aileron is self-hinged to the wing. Cut the foam

material along the lines shown in the photo to allow the

ailerons to move more freely. Cut the other aileron hinge in

the same manner. Note: Only the bottom wing surface has

operating ailerons.

3. Starting with the left tip of the bottom wing, insert the

wing into the fuselage frame. Note that the bottom of the

fuselage structure is flat along the length of the fuselage.

Remember that this is a canard model with the ailerons

facing the rear of the model.

Caution: Be careful not to damage the foam wing as it is

inserted into the fuselage.

4. Install a control horn on the bottom of the left aileron.

5. Make sure the wing is centered in the fuselage frame.

Note in the photo that the centerline of the wing is aligned

with the center of the servo openings.