GREAT PLANES YAK-55M Yakovlev Buku Petunjuk - Halaman 9

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan GREAT PLANES YAK-55M Yakovlev. GREAT PLANES YAK-55M Yakovlev 20 halaman. Arf plane

wire in each elevator half. Check that both elevator halves

are aligned. If not, remove the elevators and while holding

one leg of the elevator joiner wire, slightly bend the other.

Reinstall the elevator halves and check again.

❏

3. Coat the inside of the two elevator joiner wire holes and

the ends of the elevator joiner wire with epoxy. Install the two

elevator halves and glue the hinges with thin CA.

Install the Rudder

❏

1. Use epoxy to glue the tail gear bearing in the aft end

of the fuselage. Make sure the tail gear wire is aligned with

the hinge line.

❏

2. Install the three CA hinges into the rudder. Insert the

tail gear wire in the rudder and check the fit of the rudder on

the fin. Use pins to hold the CA hinges in position.

❏

3. Coat the inside of the tail gear wire hole with epoxy.

Install the rudder and glue the hinges with thin CA.

❏ ❏

1. Insert a 4mm axle through the right main landing

gear. Apply a drop of thread locker on the threads of the axle.

Secure the axle to the landing gear with a 5mm nut. Note:

The front of the main landing gear sweeps forward.

❏ ❏

2. Attach the right wheel spat to the main landing gear

with two 2-56 x 3/8" machine screws, two #2 flat washers

and two 2-56 nuts. Apply threadlocker to the threads of the

machine screw before installing the nuts.