GREAT PLANES Yard Stik ARF Buku Petunjuk - Halaman 7

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan GREAT PLANES Yard Stik ARF. GREAT PLANES Yard Stik ARF 16 halaman.

7. Use medium CA to glue the rudder to the stab. Use a

small builder's square to make certain the fin is perpendicular

to the stabilizer.

Mount the Fuselage Parts

1. Identify the molded plastic mounting parts and lay

them out on your workbench as shown in the photo. The

front of all the parts is facing upward.

2. Note that the front of the boom is the end with the wood

plug. Slip the fuselage parts onto the boom in the order that

they are laid out in the photo. Arrange the parts so the front

battery holder mount is 3-1/2" [90mm] from the front of the

boom (as shown in the photo at step 5) and the front wing

mount is approximately 7" [180mm] from the front of the

boom. The rear wing mount should be approximately 19"

[480mm] from the front of the boom. The exact location of the

wing mounts will be determined later when balancing the

model and the tail wire mount will be positioned when the

pushrod wires are installed.

3. Use medium CA to glue the fuselage boom to the

stabilizer and fin.

4. Fit the main landing gear wire onto the front of the

battery holder. Then, mount the battery holder to the

battery holder mounts previously installed on the fuselage.

5. Position the battery holder and battery holder mounts

so the front battery holder is 3-1/2" [90mm] from the front of

the fuselage boom. Make sure the battery holder and battery

holder mounts are vertical. Then, use a few drops of thin CA

to permanently glue the mounts to the fuselage boom.