ADEMCO LYNX Manual Sistem - Halaman 10

Jelajahi secara online atau unduh pdf Manual Sistem untuk Sensor Keamanan ADEMCO LYNX. ADEMCO LYNX 14 halaman.
Juga untuk ADEMCO LYNX: Panduan Pengguna (17 halaman), Panduan Memulai Cepat (8 halaman)

Halaman Cetak

Ademco Lynx System Manual

system will announce "END MESSAGE" and "REC MESSAGE" will not be displayed. If the

message center is full all old messages must be deleted before new messages can be recorded.

See Deleting Messages section.

Message Playback

The lighted word MESSAGE indicates that a new message is in memory. After playing the message, the

MESSAGE display turns off.

To play a message, press [FUNCTION] + [PLAY].

All recorded messages will be announced sequentially. A short beep will sound between messages.

To skip a message, press [*].

NOTE: If a wireless keypad has been installed and is programmed for quick arming, it cannot

be used to activate message playback or adjust the volume. In this case, you must use the

master keypad to perform these functions.

Deleting Messages

To delete all messages:

1. Press [FUNCTION] + [PLAY].

2. While the messages are being announced, press [FUNCTION] + [DELETE].

3. A double beep will sound confirming that the messages have been deleted.

Adjusting the Volume

The volume level of message playback, system announcements, and status beeps can be changed. You

can also mute system announcements if desired.

To adjust message playback/system announcement volume:

1. Press [FUNCTION] + [VOLUME] + [3] to increase or [6] to decrease volume level.

2. Repeat the key sequence until the desired volume level is achieved.

To mute system announcements:

1. Press [FUNCTION] + [VOLUME] + [OFF].

2. The volume level will be restored to the level that was selected prior to muting the sound.

Paging Features

Automatic Paging

http://alpha.adt.com/help/261[11/14/2018 8:02:22 PM]