Autonics ADS-SE2 Manual - Halaman 3

Jelajahi secara online atau unduh pdf Manual untuk Aksesori Autonics ADS-SE2. Autonics ADS-SE2 6 halaman. Door side sensor

Halaman Cetak

ADS-SE1/2

Installation

Controller

1. Follow as below when adjusting wiring length.

Cut off the wiring length as much as user needs.

Connect the wire to the terminal after taking off the wire

covering. It is easy to connect if soldering the end of the

wires.

※ Be sure of connecting wires in power off.

※ Follow the figure when cutting off the wires of sensor

head. If the cover of wire is taken off too much, it may

cause damage to this product as the end of both wires is

shorted.

17mm

2. Match wires in the number of terminals and connect

them.

Do not connect extended wire to the wire of sensor head.

It may cause malfunction by noise.

Do not connect two wires or more to a terminal.

Output (N.O.) (N.C.)

Power

(12-24VAC/VDC)

Output (N.O.) (N.C.)

Power

(12-24VAC/VDC)

C-18

Outer shield wire

Inner covered wire

9mm

<1-channel>

Emitter

Receiver

(gray)

(blue)

<2-channel>

①

②

①

②

Emitter

Receiver

(gray)

(blue)

Connection method for power and output wires

• Press a connecting button and wiring it.

• It does not operate normally if the wiring is connected

conversely.

• Make sure of connecting power wire to the terminal 4,

and 5. Otherwise, It may cause damage to this product.

• Allowable diameter of power and output wires

-Single and Stranded wire: 0.2 to 1.5 mm

Caution for installing controller

Fix a controller with 2 fixing bolts.

Process the fixing holes of a controller by M4.

Refer to "

Dimension" for the position of holes.

Do not tighten bolts to fix a controller. The fixing holes of

controller may be broken.

Sensor

1. Make a hole on the side post of auto door as

follows.

When not using the mounting bracket

① One push method

• Mounting hole for sensor head:

• Panel thickness for sensor head: 1.5

② Screw method

• Mounting hole for sensor head: M10×0.75mm

• Panel thickness for sensor head: 1.5

When using the mounting bracket

① One push method

• Through hole for sensor head:

• Fixing screw hole for bracket: M4 Tap or Ø3.5mm

② Screw method

• Through hole for sensor head:

• Fixing screw hole for bracket: M4 Tap or Ø3.5mm

※ Check the mounting holes for the head of emitter and

receiver are in parallel for the optical axes.

※ Grind around the mounting holes drilled smoothly.

It may hurt by sharp parts and cause malfunction by the

inclined sensor head.

±0.1

12.2

±0.5

13 to 14mm