DBI SALA NANO-LOK SRL 3101264 Buku Petunjuk - Halaman 10
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Sensor Keamanan DBI SALA NANO-LOK SRL 3101264. DBI SALA NANO-LOK SRL 3101264 15 halaman. Self retracting lifelines
Halaman Cetak
3.0 INSTALLATION
3.1
PLANNING: Plan your fall protection system before starting your work. Account for all factors that may affect your safety
IMPORTANT:
In most applications, the Nano-Lok SRL can be connected to the anchorage or the harness Dorsal
location. Either orientation is allowed; except as noted in Section 4.7.
3.2
ANCHORAGE:
3.3
HARNESS MOUNTING:
•
Single SRL Harness Interface:
1.
Loosen the Harness Webbing:
2.
Open the Harness Interface:
3.
Position the Harness Interface around the Web Straps:
4.
Attach the Nano-Lok SRL to the Harness Interface:
WARNING:
Harness Interface is unlocked. To avoid accidental release of the connection, always make sure the Harness
Interface is locked before using the Harness and attached Nano-Lok SRL. Failure to do so could result in injury
or death.
NOTE:
It is also acceptable to connect the Nano-Lok SRL to the Harness Dorsal D-Ring with a Carabiner or
Snaphook.
•
Twin SRL Harness Interface:
1.
Loosen the Harness Webbing:
2.
Open the Harness Interface:
Connector.
3.
Connector.
4.
Position the Harness Interface around the Web Straps:
5.
Add the second Nano-Lok SRL on the Harness Interface:
closed.
6.
Close the Harness Interface:
NOTE:
Older ExoFit harnesses may require a different Twin SRL Harness Interface. See Appendix A.
The Red Band on the knob end of the Harness Interface Locking Pin will be exposed if the
10