Hifonics BRUTUS BRE100.4 Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penguat Hifonics BRUTUS BRE100.4. Hifonics BRUTUS BRE100.4 18 halaman. Brutus elite series
Halaman Cetak
BRE2000.1D MONO AMPLIFIER APPLICATIONS
Basic application
Interconnect cable checklist:
- Connect the line inputs to a Radio/CD RCA outputs or line output of the
full range primary amplifier with good quality RCA cables. A "Y" adapter
may be needed as shown in the diagram.
- Use at least 16 gauge speaker wiring. These amplifiers have dual
speaker terminals, simplifying the hookup of multiple speakers. The 2
positives are the same and the 2 negatives are the same.
Crossover frequency control checklist:
- LOW PASS: 35Hz to 250Hz
- SUBSONIC:15 Hz to 35 Hz
- BASS EQ: 0 to 10dB
- PHASE: 0 to 180 degrees
Level control checklist:
- Refer to the section "Setting up systems after installation for best
performance"
*
DESIGNATED
MONO LINE INPUT
B O O S T
H F R - 3
MI N MA X X
Dual Subwoofer Application
*
DESIGNATED
MONO LINE INPUT
B O O S T
H F R - 3 MI N MA X X
7
Minimum final loudspeaker impedance:
- 1 ohm.
FULL RANGE
STEREO LINE INPUT
Note: You can use the Radio/CD designated mono line output
*
or a full range stereo line output. For full range stereo line output,
you will need an optional "Y-Adaptor" as shown
BRUTUS
ELITE
BRUTUS
ELITE
Y-ADAPTOR
NOT USED
MONO
SUBWOOFER
1-OHM MINIMUM
REMOTE TURN-ON
CHASSIS GROUND
TO BATTERY +12v
VIA FUSE
PARALLEL MONO
SUBWOOFERS
2-OHMS SVC EACH MINIMUM,
or 4-OHMS DVC EACH MINIMUM
MONO
SUBWOOFERS
REMOTE TURN-ON
CHASSIS GROUND
TO BATTERY +12v
VIA FUSE