Afikim Breeze-C Panduan Pemeliharaan - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Pemeliharaan untuk Skuter Afikim Breeze-C. Afikim Breeze-C 18 halaman.

Halaman Cetak

10.3

The fault code from the SP1 Programmer :

(More codes you can see on the hand programming SP1).

When the fault exists, connect the SP1 programmer's connector directly to the controller

SDRIVE or to the charging socket, using a special wiring adaptor.

The fault will be displaed on the SP1 programmer display.

Table 1:

Fault Code

Action to troubleshoot

0300

Check the tiller & throttle wiring to the controller, then retest

0815

Check the tiller & throttle wiring to the controller, then retest

0A00

Check the sleep mode parameter is set correctly, then retest

0E08

Check the tiller & throttle wiring to the controller, then retest

0E07

Check the tiller & throttle wiring to the controller, then retest

1501

Check the solenoid brake's wiring & connections to the controller, then retest

1502

Check the solenoid brake's wiring & connections to the controller, then retest

Check the batteries' wiring & connections to the controller, then retest

1600

Also possible a condition of high load driving downhill.

1601

Check the batteries' wiring & connections to the controller, then retest

1E08

Check the wiring & connections to pin 4 of the programming socket, then retest

1E09

Check the wiring & connections to pin 6 of the 14 way tiller connector, then retest

Inhibit 2 - check EMB manual brake micro switch.

1E0A

N/A for Breeze C.

2C00

Check the batteries' wiring & connections to the controller, then retest

2F01

Check the throttle is not displaced on start-up, or does not return to natural condition ,

then retest

2F01

Check the tiller & throttle wiring to the controller, then retest

3100

Battery connected whilst scooter is switched on. Turn off, wait 10 seconds, then retest

3B01

Check the motor wiring & the connections to the controller, then retest

3D02

Check the motor wiring & the connections to the controller, then retest

3D03

Check the motor wiring & the connections to the controller, then retest

4401

Internal controller fault. Replace the controller (Make sure for the parameters setup).

5300

Programmable parameter changed. Turn the scooter off, then ON again, then retest

All the others

Check all wiring & connections to the controller, then retest

Table 2:

No power to programmer

Scooter drives slowly

Status indicator does not light

Reverse alarm does not sound

Scooter will not drive in reverse

C:\Users\avner\Desktop\holland conference\Breeze C\9-------------------------MAINTENACE\3 -------------- Service Manaul\Service manual Eng\Breeze C Maintenance (19-7-2013) PRC4014b.doc

Check the wiring & connections to the batteries, then retest

Check the wiring & connections to the programmer, then retest

Check the controller is programmed correctly, then retest

Check the speed limiting function is not active e.g. seat raised, then retest

Check the solenoid brakes are not jammed, then retest

Check the wiring & connections to the status indicator, then retest

Check the wiring & connections to the buzzer then retest

Check the buzzer is working correctly, then retest

Check the scooter is programmed correctly then retest

Check the tiller wiring & connections, then retest

Check the reverse switch is working correctly, then retest