Afikim Breeze-C Panduan Pemeliharaan - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pemeliharaan untuk Skuter Afikim Breeze-C. Afikim Breeze-C 18 halaman.

7. Controller Programming / Setup

If the user cannot find a position on the half speed limit

switch control that suits him, the controller can be

programmed to meet his needs. The controller can be

programmed in two ways – with an SP1 Programmer or

specialist PC software and interface cable.

The SP1 is a small hand-held unit which can be plugged into

your controller to alter the program or into

the charger

socket .

The PC Programmer is a piece of PC software and an

interface cable. When the software is installed onto a PC, it

can then be connected to the controller by using the special

interface cable. The controller can then be programmed

using a windows type environment

The programming tools may be included with your scooter. If

they are not, the scooter distributor or service agent or

scooter manufacturer will are able to program the controller.

If you have a programmer, read the user guide before you

use it.

If you re-program your controller, make sure that you

observe any restrictions given in your scooter user manual.

Note any changes you make for future reference.

Programming should only be conducted by healthcare

professionals with in-depth knowledge of PGDT

electronic controllers. Incorrect programming could

result in an unsafe set-up of a scooter for a user. PGDT

accept no liability for losses of any kind if the

programming of the controller is altered from factory

pre-set values.