Maintronic Sx2 Tuning-Dongle Panduan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Sepeda Maintronic Sx2 Tuning-Dongle. Maintronic Sx2 Tuning-Dongle 5 halaman. For ebike; with bosch active / bosch performace line cablekit sx2kb-perf

Scope of delivery

1x cablekit Bosch Active / Performance Line with
3,5mm stereo jack socket (5)
2x gel insulated blade connectors (2)
1x Sx2 Tuning-Dongle (6),
1x user manual Sx2 Tuning-Dongle with Bosch
Classic Line cablekit
Image label Bosch Active/Performance Cablekit
3
black
1
2
red
black
green
yellow
6
8
+5V
Sx2
switching time of the speed sensor. The shorter the
switching time, the sooner is the switchoverpoint and
conversely. Try to turn up the pedal by hand while the
engine is turned off till 50km/h and watch the speedo-
Installation Bosch
The best solution is to connect the cablekit directly be-
hind the speedsensor plug inside of the engine termi-
nal.
It is located behind the stone chip cover of the engi-
ne which is screwed on with 3 Torx screws. At first the
crank crank has to be removed. For this reason the fol-
lowing special tools are required: 8mm 5-hex key to un-
lock the crank screw, Isis crank puller for dismounting
the crank. And a Torx T20 key for the chip cover screws.
4
red
Once the crank and the protective cover are removed
you get access to the speedsensor plug(1). The next
step is to unplug the speed sensor plug (1) from the en-
gine carefully.
5
orange
Connect the Sx2 Tuning-Dongle parallel to the speed-
sensor. Please take care of the polarity. Red to red (3)
and black to black (4). The orange wire (5) is connected
to the red wire which leads to the + wire of the control
unit Intuvia (6).
7
- Ground
4
Is an extension of the connection cable possible?
ANSWER:
Yes, with a commercial standard headphone extension
cord, the Sx2 Tuning-Dongle can be placed anywhere on
Creation date:
For connecting the wires with the blade connectors
insert each wire (without stripping) of the Sx2 Tuning-
Dongle cable into the one-sided openings of the blade
connectors (2).
The related wires of the speedsensor and the + wire
of the control unit Intuvia (6) are inserted into the
through-opening of the blade connectors. Now press
down with your hand the blade connectors (2) firmly.
Compress with a pliers as possible parallel.
5
01 / 2014
1
6