Maisi M30 Panduan Memulai Cepat - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Kamera Dasbor Maisi M30. Maisi M30 17 halaman.

I cannot get to the settings menu?

Make sure the camera is not recording (you can press OK button to stop recording) and press

the Menu button (top right one) to bring up the Record/Picture/Preview Mode Menu. Press

Menu button again to bring up the System Menu.

What is "Loop Recording"?

All of our dash cams are currently utilizing the loop recording system. The options are 1/3/5

minutes. For example, if it is set to 5min, the camcorder will generate a file every 5 minutes.

Once the SD card capacity is full, the oldest file will be overwritten by the latest one.

Is there a "Emergency" button to start recording and save on demand on the

camcorder?

Yes. Just press the Menu button once (when the camera is recording) to achieve this function.

There will be an exclamation mark

next to the counter. Press OK button to stop the

emergency recording. Emergency recordings will not be overwritten.

What is a "G-Sensor" feature on a dash camera?

A "G Sensor" is a feature / setting that allows a specific video file that is actively being

produced / recorded to be "locked" and protected from becoming deleted as the camera

continues to record video while in " loop". Cameras have low, medium and high settings for

G-sensor. If the setting is set too high, then the camera may "lock" files every time you come to

a quick stop or run over a pothole. The G-Sensor setting must be used cautiously and

experimented with for each driver and vehicle. It is suggested that a new camcorder owner

drive with G-sensor set to off or in the low setting in order to get a "feel" for how it functions in a

particular vehicle and driving style.

How is the motion detection function for?

Under motion detection, the camcorder will capture moving objects in front of your car. You can

use it in parking lot. The battery of the camcorder will not last long, so it is recommended to

use a power bank to power the device.

Why there is strips in the image?

Please adjust the Frequency (50Hz/60Hz) of the camcorder.

In case of device shutdown in abnormal condition:

Please press the "RESET" button on the button of the device and restart the device.

Why my device is showing resolution: 2304*1296 25P? Not 2304*1296 30P?

Please adjust the System Mode from PAL to NTSC.

Page 16 of 16